Home > NH3 Module Kit > dashCAN+
ECM's dashCAN+ allows the display and analog output of LambdaCAN, NOxCAN, NH3CAN, and baroCAN module parameters. Simply attach dashCAN+ to the CAN bus and select one or two modules. Any parameter from those modules can be displayed and converted to analog outputs, Module selection, parameter selection, display update rates, analog output scaling, and LED intensity are programmable via buttons on the dashCAN+. Multiple dashCAN+s can be attached to the CAN bus. ECM's dashCAN+ is a superb addition to your ECM LambdaCAN, NOxCAN, and baroCAN network.
  • Display and Output Parameters from One or Two Modules
  • 6 Analog Outputs (if one module selected)
  • 3 Analog Outputs per Module (if two modules selected)
  • 0 to 5V or 0 to 1V (selectable) Programmable Outputs
  • Opto-isolated Analog Outputs (from CAN Power)
  • Programmable for Display Update Rate and Intensity
  • Readable when Cold (LEDs)
  • 8 to 28 VDC, 150mA at 12VDC
  • -40 to +105°C Operation
  • 105 mm x 64 mm x 165mm
  • 680 gm
Jump to Optional Kits and Parts
Related Downloads:
dashCAN & dashCAN+ Brochure (10-16-2011, 203KB)
Rackmount Installation Guide (197KB)
Firmware Update Procedure for Display Heads (158KB)
Ordering Information, Complete Kit P/N: dashCAN+
The complete kit includes the following parts:
2.Flexi-Eurofast Cable, 0.3m09-041
3.Eurofast "T" Connector09-051

Optional Kits and Parts:

1.19" Rackmount Panel (holds up to 4 display heads or 4 dashCANs)12-011